<driver id="driver/ljet3d">
 <name>ljet3d</name>
 <url>http://www.cs.wisc.edu/~ghost/doc/printer.htm</url>
 <execution>
  <ghostscript />
  <prototype>gs -q -dBATCH -dPARANOIDSAFER -dQUIET -dNOPAUSE -sDEVICE=ljet3d%A%Z -sOutputFile=- - | perl -p -0033 -e &quot; s/^&amp;l\d+[aA]/$&amp;%E/; &quot; </prototype>
 </execution>
 <comments>
  <en>
    This driver is the same as &quot;ljet3&quot; but with duplex
    printing support.
  </en>
 </comments>
 <printers>
  <printer>
   <id>printer/Generic-PCL_5_Printer</id>
  </printer>
  <printer>
   <id>printer/HP-LaserJet_3D</id><!-- HP LaserJet 3D -->
  </printer>
  <printer>
   <id>printer/HP-LaserJet_3P_w_PS</id><!-- HP LaserJet 3P w/PS -->
   <comments>
    <en>Same as ljet3 but activates duplex mode. (Cannot be activated by PS code because Ghostscript ignores this?)</en>
   </comments>
  </printer>
  <printer>
   <id>printer/Kyocera-FS-1500</id>
  </printer>
  <printer>
   <id>printer/Kyocera-FS-1550</id>
  </printer>
  <printer>
   <id>printer/Kyocera-FS-1550plus</id>
  </printer>
  <printer>
   <id>printer/Kyocera-FS-3400</id>
  </printer>
  <printer>
   <id>printer/Kyocera-FS-3400plus</id>
  </printer>
  <printer>
   <id>printer/Kyocera-FS-3500</id><!-- Kyocera FS-3500 -->
  </printer>
 </printers>
</driver>
